How to edit basic disorders When you use a home computer not working
Find a Drive C: not found may be due to the hard drive Bad Sectors solution.
Try Scan Disk to repair the waste for Window 98 and ME to boot from the disc to boot a: try Scandisk on how create a boot to the Settings -> Control Panal -> Add / Remove Programs -> select the Tab Startup Disk ->. Click Create Disk for Window XP to boot from the CD and select Repair and then try Scandisk view
If lucky can be repaired successfully. Hurry to back up important data out. Then go to the store to check or change the new
If you find that hard waste can not be repaired anymore, pull it out to the store to check or change to new
Installing hard drive: Before installing the hard drive. Need to make sure the jumper before the IDE1 cable line is connected to the second drive is the Master and Slave Before the installation should be viewed as check. Jumbo is set correctly to Porto. After set the jumpers and then. The hard disk is inserted into the case. By the side of the interface for connecting cables at the back. Slide the drive into the box to fit in the slot for inserting bolts. Then put a screw nut crude Knot the end and should include those 4 and then connect the patch. Power cables and patch cables will be different. The hard drive and CD-ROM drive will be able to cable the same cable 40-pin or 80 pin, which currently is used mostly cable 80 pin the floppy disk drive will use the cable 34. pin and observations, it is going to be crossing the line taken by Must first connect sprain IDE connector on the motherboard first. Most leg lock position already. But there is an observation for a while Edge of the patch cable. One side is red, which will need to stay in the first leg will be observed on a screen mounted to the motherboard as well, then bring the other end plugs into the back of the hard disk interface. To the red edges are aligned with slots for the power cord. Then plug the power cord into the back cavity. That if you put the wrong power cord can not be inserted into the channel. Power and cable lines will be red. Which is as close to the side line pad memory simply call the red light next to the line patch red sure enough symptoms 1. Not open attached no beep fan does not rotate symptoms. 2 lit screen is not installed symptoms 3. Problem “screen. Blue “Symptoms 4. for drive C: not found.